cBN ENDMILL Series
Hardend Material (HRC40~HRC65) < STAVAX・NAK80・SKD11・SKH etc. >
Ball type – Spiral flutes & Straight flutes
- Size : R0.1 – R3.0
- 2Flutes – 3Flutes
Corner R type – Spiral flutes & Straight flutes
- Size : Φ0.3 – Φ6.0
- Size : R0.02 – R0.5
V type – Straight flutes
- Edge angle : 30° – 90°
Reamer type – Spiral flutes
- Size : Φ1.5 – Φ6.03
Cutter type – Straight flutes
- Size : R0.1 – R3.0
- 2Flutes – 3Flutes
Requesting an estimate
Please fax a work drawing or tool drawing (hand drawing is acceptable). An estimate will be sent to you the same day or the next day. Kyowa can propose tools that suit the work material and/or other environment conditions.
Fax: +81-4-7147-7772
Flow of order
Precautions for use
- Handle products with sufficient care as they have a sharp cutting edge.
- Tools and work materials are very hot right after they are used. Do not touch them directly with your hands as there is a risk of burns.
- Protect your tools from being broken by scattering of cuttings or improper use of equipment. Specifically, set the machinery covers in place and wear protection such as safety goggles.
- Never attempt to touch the workpiece with bare hands. The burrs on the workpiece can cause an injury.